This product works well. I bought both the right and the left crown stops and it does make crown work faster. I have been an old school guy who learned to cut crown laying flat on the saw table. The past few years I have been cutting crown standing up with out stops. It still takes a good eye( or a tape measure) to set the stops.
The stops are much easier than doing it by eye, They don't work well on pieces much shorter than 12 inches but if you draw a pencil line or tape a line on the saw table between the stops you can still get good results.
Only down side is they are a little expensive.Get more detail about Hitachi 321374 Miter Saw Crown Left Side Molding Support for C10FSH and C10FSB.
No comments:
Post a Comment