This is one fantastic tool, and if you do not believe me look at reviews over the web such as [....]. The nails MUST be high quality such as Senco. I had some jam in this gun because the were an off brand I tried to use as I ran out of the Senco DA type I use. I use the Paslode yellow short fuel can.
I can even over-drive in hard wood if I want. Not sure what was wrong with the other user's review tool, could be a few things, most likely the fuel is old[none is included, have to check the date code on the can], or the nails are jamming because they are not like quality 15 ga SencoDA's, or the wrong type/gauge such as "UA "or Bostich angle which look similar but are not for this gun.
This is an excellent design, well made in Taiwan, not China[wish it was made in USA].
Balance is excellent. Makes other battery only guns look like framers, at about 4#'s it is great for use overhead and on ladders, clip can be used to hang gun easily. This is so lightweight and precise I hardly use my many other air nailers. The 16 ga. straight Paslode I have, never gets used now, much larger,no angle, heavier, balance nowhere as good. The battery last a very long time and is low cost to replace unlike the other expensive higher voltage guns. The bonus screwdriver is nice for small , light work such as electrical. The molded case has extra room and hold gas cans too.
The complaints are minor. The nose cover does not stay on the storage stud, falls off easily and the door on the gas cover seems like it could break as it has a thin plastic fold as a hinge not a pivot pin like the Paslode or my Hitachi cordless RH Framer .
Just thrilled with this tool overall. Get more detail about Hitachi NT65GA 15 Gauge 2-1/2-Inch Gas Powered Angled Finish Nailer.
No comments:
Post a Comment